Gen 2 Upfitter Switch Tailgate Release Kit - just do it!

Ever sit in your F-150 and wish you could 'pop' the tailgate, much like if you're in a car and you want to 'pop' the trunk?  Well, now you can! 

Long story short, you can order this kit here for $25

note: This mod only works on the 2017 Raptor with 802A package.

This modification behaves exactly as a trunk release button in a Ford sedan would. Meaning, it will not function while the Truck is moving. It will not function if the truck is not in accessory mode or turned on. The system cannot be damaged by leaving the upfitter in the on position either. Leaving the upfitter switch toggled on is the same as pressing and holding the trunk release button in a Ford sedan. Once the signal to open the trunk is sent no more power is sent to the actuator, all signals are ran through the BCM processors. This is a modification that operates as an OEM system would.

FAQ:
Q:Does this modification require permanent modification to my vehicle?
A: No. Zero factory wiring will need to be cut or spliced (aside from the upfitter switch wires)

Q: How long will this take to install?
A: Approx 30min. Less time for some who is experienced with following simple instructions and the use of a wrench (haha).

Q: Will leaving the upfitterswiatch on cause damage? or overload the tailgate actuator?
A: No. Absolutely not. By flipping the up fitter ONE single signal is sent to "pop" the tailgate, after this signal is sent no more power will be sent to the tailgate.

Q: Will this modification work while the vehicle is in motion? While the vehicle is powered off?
A: No. This modification will only work when the ignition is in the ACC/ON/RUN position and the vehicle is not moving faster than 1MPH, regardless of gear selected.


$25 Shipped via PayPal Goods and services
(Please add $6 for international shipping if outside USA).

Each kit Includes:

-DETAILED, PRINTED FULL COLOR INSTALL INSTRUCTIONS
-All required wiring and relay. Everything is prewired and labeled for ease of installation.
-Wire ties and heat shrink tubing to insulate and secure splices.
-This kit requires ZERO cuts or splicing into factory wire harnesses and takes less than 30 minutes with basic tools to install. (splicing of up fitter switch wires required)

PayPal: www.paypal.me/BrendanWebster911
Please ensure to leave shipping address!

Took me about 30 minutes to install (very complete kit!)  Just do it!  Support a Veteran!