Showing posts with label audio. Show all posts
Showing posts with label audio. Show all posts

Friday, April 20, 2018

2017 Ford Raptor rear door 6.5" and Dynamat

Recently I replaced the front door speakers and applied dynamat to the doors - HUGE difference!  I got some time to do the rear doors - just as amazing difference.  Now that all the doors are timbre matched the truck sounds EVEN better!  The Dynamat Sound Dampening really reduces extra noises as well...

Here are some quick tips in case you haven't done this before!
Here are the tools I used: (turn off your ad blocker to see!)

  
 

Welcome to the rear doors - very much like the front but only 6 x 7mm screws



he tools that were used...


flat screwdriver slot at the bottom front to help you pry off the handle...


simply pull outward, keeping in mind the tab at the rear of the handle


use your tool to pop open the panel under the handle...


now you can remove the 4 7mm screws in the handle area


 and 2 7mm underneath the door

I didnt do this on the fronts, but removing the door handle clip is really easy - just pry down on the tab at the bottom of the clip, it pops right out!

remember to unplug the connectors - I had 2 behind the handle and of course, the wire clip going to the speaker itself...  naked door!!!


You will still use your 7mm socket, remove the 3 screws from the speaker - there are 2 pegs in the speaker mount - don't worry the speaker won't fall out :)

ok - NOW the door is really naked :)


look at the stock unit... yikes!  makes you think WHAT ARE THOSE!!!?!?!?


Slowly peel back the sealant on the vapor barrier, use a utility knife carefully - you'll re-use the stuff.

Oops - forgot this tool!  



Also - this is the Dynamat Extreme pack I used, 9 sheets - and I've used 2 sheets per door!
try to get as much inside the door panel as you can...



Here's how I do the speaker holes - start at the center and cut radially to the edges, I usually do 8 slices (like cutting a pizza)


another pic slicing...


next - put each slice behind the door and tuck it in tightly against the back of the panel - this acts as a good seal for the speaker mount and also adds sound deadening right at the speaker


now you can see the finished speaker opening - be sure you use a utility knife to poke the Dynamat where the speaker mount screws are...


keep working on the door panel with dynamat and rolling it out


here you can see the new speaker next to the OEM one...



note that there is no 'hole' in the mouting bracket for the wiring harness so I chose to pinch the wires in between the dynamat and bracket





The dynamat is soft enough to allow some play in the wiring so I'm not worried they'll wear much...


Put it all back together again, and you're done!

The sound of these Pioneer speakers is lightyears better than the stock speakers!
Hope you enjoy!


Tuesday, March 6, 2018

2017 Raptor Part 1 802a Stereo Upgrade - Pioneer TS-A878 center channel

FINALLY getting around to upgrading my speaker(s) - did a quick video on the process for the center dash speaker - yes it's just one. The Sony system isn't terrible in the Raptor, but it needs more help for sure - the range of the OEM speakers is pretty stale... From lots of reviews on the forums, these Pioneer A-series are an inexpensive addition to really make the audio 'sing' 😎

Parts needed for this task:



Next will be the doors!

Added Deaver +3HD leaf springs today!

 The Raptor tends to 'squat' a bit with the travel trailer, so after many days of research I bottomed out (sic) on the Deaver +3HD l...